EOTech HWS 558 holographic sight - compatible with 1-3 generation night vision equipment

Zero compromise, one hundred percent precision - these are the only rules that work in the field. The tougher the conditions, the greater the detail becomes, which is why the HWS-558 holographic sight is your closest friend in battle. Made in the USA by EOTech - one of the largest manufacturers of gun equipment and accessories.

• 

  Long operating time

  over 2000 hours

• 

  Brightness adjustment

  20 degrees for daytime operation

  10 degrees for night vision

• 

  Fits on:

  Weaver rail

  MIL-STD-1913

• 

  Waterproof

  up to 10 m

Don't lose sight of your target

The HWS-558 collimator keeps the target "in sight" even when your sight is off axis. This allows you to maintain the precision of your shot, despite looking at the target from different angles - this feature of the sight is essential when aiming from behind an obstacle, such as a tree or wall.

Have confidence in any situation

The red dot always remains in the centre. Its function is to direct you to the most precise shot. In emergency situations, however, your support will be the wider spectrum - a circle that will show you the area of the shot when speed, not precision, is most important.

Work at night too

Compatibility with 1-3 generation night vision means that with the holographic sight you will not be surprised by any situation. After dark, your shooting precision remains the same. The collimator, moreover, works in a temperature range of -40° to +60°. It is no surprise that EOTech equipment is used by both police and military all over the world.

Adjust brightness

Different conditions - different brightness levels. Not only for daytime activities, where you have 20 brightness settings at your disposal, but also for nighttime activities. EOTech has prepared 10 additional settings to work with 1-3 generation night vision devices.

Mount in a flash

The holographic sight is designed for operations that change from minute to minute, and you always need to be prepared. You mount (and remove) the HWS 558 very quickly - on a Weaver or MIL-STD-1913 rail.