

- Average: 0
Nobody has posted a review yet
Rate / write a comment Sales representative and Consultant
Casper Antechi
Helpdesk
+44 (020) 3290 1199
Nobody has posted a review yet | |
Rate / write a comment |
Helpdesk
+44 (020) 3290 1199
iProtect 1216 is a precise and reliable spy bug detector and localiser of potential listening devices, cameras and telephones that apply wireless connection in GSM, WiFi and WiMax networks and those based on Bluetooth technology.
50 MHz - 12 GHz
6 h
Li-Ion 1150 mAh
built-in
The key advantage of the spy bug detector iProtect 1216 is the application of 6 totally independents channels each of which supports other frequency range.
Frequency range of the spy bug detectorProtect 1216 was split in 3 segments each of which is displayed on a separate bar graph:
Separate indications allow the operator to better understand what type of signal was detected to detect several signals at the same time and to maintain the detection capability near sources of interference.
The third ‘microwave’ band of iProtect 1216 covers frequency range 3-12 GHz. This unit detects Wi-Fi and other wireless protocols operating at 5 GHz and at any higher frequencies. The frequencies of microwaves are usually more hidden, however the spy bug detector iProtect 1216 can easily find these signals.
The alarm function helps the operator to reject background interference by adjusting the threshold. When the signal exceeds the alarm threshold, the device makes a warning sound. The alarm is also extremely convenient when testing hard-to-reach places or keeping the device in a "guarding" mode. The alarm threshold has 48 tuning steps.
In the "ONE BAND" display mode, iProtect 1216, in addition to the bar chart, shows the histogram for the selected band. The histogram draws a history of the signal acquired within the last 5 seconds. This is an extremely useful feature when observing intermittent or periodic signals or during quick checking the area with a probe.
The spy bug detector iProtect 1216 has a much higher sensitivity for 3G, Wi-Fi and Bluetooth frequencies compared to conventional RF detectors. This advantage has been achieved thanks to additional radio frequency paths in the circuit designed for specific ranges.
Apart from bar charts iProtect 1216 can identify some types of signals and display a message about their detection on the display: wireless DECT device in "idle" state, active DECT, GSM, 3G, Wi-Fi / Bluetooth devices and etc.
Specification of the Spy bug detector iProtect 1216 | |
---|---|
1 particular channels | |
Frequency range 1 |
|
RF connection | SMA (band 1 and 2), 50 Ohm |
Microwave antenna | built-in (band 3) |
Thresholds setting | 48 moves |
Detection distance | 1-10 m |
Operation time | up to 6 h |
Power supply | Li-Ion 1150 mAh, 3,7 V |
Dimensions of the spy bug detector | 173 × 71 × 21 mm |
Weight | 265 g |
Inbox |
---|
Specification of the Spy bug detector iProtect 1216 | |
---|---|
1 particular channels | |
Frequency range 1 |
|
RF connection | SMA (band 1 and 2), 50 Ohm |
Microwave antenna | built-in (band 3) |
Thresholds setting | 48 moves |
Detection distance | 1-10 m |
Operation time | up to 6 h |
Power supply | Li-Ion 1150 mAh, 3,7 V |
Dimensions of the spy bug detector | 173 × 71 × 21 mm |
Weight | 265 g |